Wacker Neuson CRT 48-31V Manuel de l'opérateur télécharger pdf (Page 36)

Maintenance CRT 48

36 wc_tx000642gb.fm

5.9 Drive Belt

See Graphic: wc_gr003775

To replace the drive belt:

5.9.1 Place the trowel on a flat, level surface with the blades pitched flat.

5.9.2 Disconnect battery.

5.9.3 Remove the beltguard.

5.9.4 Remove the 3 bolts (a) holding the universal joint to the drive pulley.

5.9.5 Remove the old belt and install a new one.

5.9.6 Reverse the procedure for assembly. Align the bearings and shaft as

straight as possible. Adjust pulley offset and center distance to values

as shown.

5.9.7 Torque the universal joint bolts (a) to 14 ±1,4 Nm (10±1 ft.lbs.).

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 75 76

Pas de commentaire

Wacker Neuson CRT 48-31V Manuel de l'opérateur Page 36