Wacker Neuson GP 6600A Manuel de l'opérateur télécharger pdf (Page 40)

Maintenance GP/GPS 6600A

6.6 Cleaning the Sediment Cup

See Graphic: wc_gr000029

6.6.1 Turn the fuel valve off.

6.6.2 Remove the sediment cup (a) and the O-ring (b).

6.6.3 Wash both thoroughly in a nonflammable solvent. Dry and reinstall

them.

6.6.4 Turn the fuel valve on and check for leaks.

6.7 Carburetor Adjustment

See Graphic: wc_gr000032

6.7.1 Start the engine and allow it to warm up to operating temperature.

6.7.2 Set the pilot screw (a) two turns out. See Note.

6.7.3 With the engine idling, turn the pilot screw (a) in or out to the setting

that produces the highest rpm.

6.7.4 After the pilot screw is adjusted, turn the throttle stop screw (b) to

obtain the standard idle speed. See Technical Data.

Note: On some engines the pilot screw is fitted with a limiter cap (c)

to prevent excessive enrichment of the air-fuel mixture in order to

comply with emission regulations. The mixture is set at the factory and

no adjustment should be necessary. Do not attempt to remove the

limiter cap. The limiter cap cannot be removed without breaking the

pilot screw.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Pas de commentaire

Wacker Neuson GP 6600A Manuel de l'opérateur Page 40